BOS4025 Columbia Southern Unit V OSHA Safety and Health Assessment Please see attachment that needs to be completed and in APA Format. Below is the unit le

BOS4025 Columbia Southern Unit V OSHA Safety and Health Assessment Please see attachment that needs to be completed and in APA Format. Below is the unit lesson study guide. 
 Course Learning Outcomes for Unit VUpon completion of this unit, students should be able to:1.Apply OSHA safety and health standards to the workplace.1.1Identify compliance requirements of OSHA Subparts L–N.5.Discuss common violations of OSHA standards.Reading AssignmentThis course does not have a specific textbook. Instead, you will be using actual OSHA standards from the U.S. Department of Labor’s OSHA website as well as other relevant materials. To access the required reading material for this unit, copy and paste the URL into your Internet browser.Occupational Safety & Health Administration. (n.d.). OSHA standards: 1910.155-1910.184 (Subparts L through N, including appendices).Retrieved from http://www.osha.gov/pls/oshaweb/owasrch.search_for… Take Test: Unit V Assessment
Question 1
1. What is the correct definition of dry powder?
A compound used to extinguish or control Class D fires
A compound used to extinguish or control Class A fires
A compound used to extinguish or control Class B fires
A compound used to extinguish or control Class E fires
5 points
Question 2
1. All wiring and equipment on overhead or gantry cranes shall comply with the applicable
electrical sections of __________.
Subpart N
Subpart S
Subpart O
Subpart Z
5 points
Question 3
1. In an overhead crane, what must be displayed on either side of the crane so as to be
visible from the ground?
The name of the crane’s manufacturer
Certification of the annual exhaustive inspection
The crane’s rated load
The year the crane was purchased
5 points
Question 4
1. Which of the following types of vehicles is not covered by 29 CFR 1910.178, Powered
Industrial Trucks?
Motorized hand trucks
Fork trucks
Earth-moving vehicles
Platform lift trucks
5 points
Question 5
1. Workplaces using electrically powered industrial trucks will have battery charging areas
somewhere in the plant. Which of the following is NOT a requirement in the standard?
Taking precautions to prevent open flames, sparks, or electric arcs in charging
areas
Placing charging stations outdoors in a covered area
Locating charging installations in areas designated for that purpose
Prohibiting smoking in the charging area
5 points
Question 6
1. List three conditions that, if found in a wire rope sling, would require the sling to be
removed from service immediately. Include the citation for the OSHA standard where
you found the answer to the question.
Your response should be at least 75 words in length.
Arial
3 (12pt)
Paragraph
Path: p
Words:0
5 points
Question 7
Font family Font size
1. What is the correct procedure for deflating a tire equipped with a multi-rim wheel?
Include the citation for the OSHA standard where you found the answer to the question.
Your response should be at least 75 words in length.
Arial
3 (12pt)
Paragraph
Font family Font size
Path: p
Words:0
5 points
Question 8
1. What is the difference between a powered industrial truck designated D and one
designated DY? Include the citation for the OSHA standard where you found the answer
to the question.
Your response should be at least 75 words in length.
Arial
3 (12pt)
Paragraph
Font family Font size
Path: p
Words:0
5 points
Question 9
1. When an employer provides portable fire extinguishers for use by employees in the
workplace, what education or training must be provided to the employees? Include the
citation for the OSHA standard where you found the answer to the question.
Your response should be at least 75 words in length.
Arial
3 (12pt)
Paragraph
Path: p
Words:0
5 points
Font family Font size
Question 10
1. What extinguishing agents are prohibited by the Occupational Safety & Health
Administration (OSHA) for use in workplace fire extinguishers? Include the citation for
the OSHA standard where you found the answer to the question.
Your response should be at least 75 words in length.
Arial
3 (12pt)
Paragraph
Font family Font size
Path: p
Words:0
5 points
Question 11
1. OSHA’s powered industrial truck standard (1910.178) is consistently part of OSHA’s
annual list of top 10 standards violated. Discuss some reasons why this is the case.
Provide examples that illustrate your point.
Your response should be at least 200 words in length.
Arial
3 (12pt)
Paragraph
Font family Font size
Path: p
Words:0
25 points
Question 12
1. Your company is planning to build a new storage and distribution warehouse for furniture
products. Forklifts will be required to move material around the warehouse and to load
and unload trailers. The purchasing department asked you if they should buy internal
combustion engines or electric-powered forklifts. Based on the OSHA standard, discuss
the considerations that need to be part of the decision, and provide your recommendation
on the type of forklift that should be purchased.
Your response should be at least 200 words in length.
Arial
3 (12pt)
Paragraph
Font family Font size
Path: p
Words:0
25 points

Purchase answer to see full
attachment